Suzuki · Woolich Racing · Alientech KESS3
Suzuki ECU remap & dyno tuning in Phuket
Suzuki V-twins and big fours respond well to mapping because the factory calibration is cautious and the ECUs are well understood by the tools we use.
What Suzuki riders come in about
Surging at steady throttle
V-Strom and SV650 riders commonly report a light surge when cruising at constant speed. It comes from lean closed-loop fuelling and is one of the easier complaints to fix.
Factory limiters
The GSX-R and Hayabusa carry a top-speed limiter and gear-based ignition retard from the factory. For track use these are settings in the ECU, not hardware.
Throttle response
Secondary throttle valve maps on older models and throttle maps on ride-by-wire ones shape how the bike answers your right hand, separately from how much power it makes.
Models we see most
- Suzuki V-Strom 650
- Suzuki V-Strom 800 / 1050
- Suzuki SV650
- Suzuki GSX-S750 / GSX-S1000
- Suzuki GSX-R750 / GSX-R1000
- Suzuki Hayabusa
The list is a guide, not a promise. ECU support changes with the model year. Send us yours and we check it before you ride over.
How we get into a Suzuki ECU
Woolich Racing started with Suzuki and still goes deepest there. KESS3 is the fallback for ECUs it does not list.
About Woolich Racing · About Alientech KESS3
Whichever tool reads it, the map is written the same way: a baseline dyno run, your stock file saved, fuelling corrected against the measured air/fuel ratio, then verification runs. The full method is on the ECU remap page.
How a tuning day runs
From your message to the before-and-after sheet
-
01 / 06
You send the bike’s details
Make, model, year and what is fitted. We check the ECU against the tools and tell you whether it is done through the diagnostic plug or on the bench.
-
02 / 06
Check-in
Chain, rear tyre, leaks and stored fault codes. Anything that would spoil the numbers or endanger the bike is dealt with first.
-
03 / 06
Baseline runs
The bike goes on the rollers as it arrived. Power, torque and air/fuel ratio are recorded so there is something honest to compare with.
-
04 / 06
Stock file saved
The original contents of the ECU are read and archived. From here on everything can be undone.
-
05 / 06
Mapping
Fuel is corrected against the measured air/fuel ratio across revs and throttle positions. Ignition, throttle maps and the agreed settings follow, where the ECU allows it.
-
06 / 06
Verification runs
The new map is run again until the trace sits where it should. You get the before-and-after sheet and we walk you through it.
Suzuki tuning questions
Can you remap my Suzuki in Phuket?
Most fuel-injected Suzuki models can be remapped at our workshop in Kamala, using Woolich Racing and Alientech KESS3. Support depends on the model year and the ECU fitted, so send us make, model and year and we confirm before you book.
How much power will I gain?
It depends on the bike and what has been done to it. A stock modern bike usually gains little at the peak and noticeably more in the mid-range and in throttle smoothness. A bike with a full exhaust on its stock map gains the most, because the map is the furthest from right. We show you the baseline before any work, so you see the real difference on paper.
Is the remap reversible?
Yes. Before changing anything we read your original ECU file and keep it. It can be written back at any time — before a sale or a dealer visit.
How long does it take?
A power run takes about an hour. A custom remap takes from half a day to a full day, longer if the ECU has to come off the bike for bench work or if the engine is heavily modified.
Will a remap affect my warranty?
It can. A manufacturer may refuse a warranty claim on an engine whose ECU has been modified. We keep your original file so the bike can be returned to stock, but you should decide with that in mind.
Other makes
Booking
Send us the bike, the year and what is fitted.
We check that your ECU is supported, tell you which tool it needs and what it costs, then give you a slot.