Skip to content
Phuket Dyno by Phuket Garage

KTM & Husqvarna · Alientech KESS3

KTM & Husqvarna ECU remap & dyno tuning in Phuket

KTM engines are lively and their factory maps are lean and abrupt to match emissions rules. Husqvarna street models share the same platforms and the same ECUs.

What KTM & Husqvarna riders come in about

Lean, snatchy fuelling

The 390 single and the 790/890 twins are widely reported to surge at low revs and snap when the throttle is reopened. Richer part-throttle fuelling and a reshaped throttle map calm that down.

Heat and fan control

Singles and big twins both run hot in slow traffic here. Where the ECU exposes fan thresholds we can bring the fan in earlier.

Exhaust and airbox changes

These bikes are sensitive to intake and exhaust changes. A map written for the parts on your bike behaves very differently from a file made for someone else’s.

Models we see most

  • KTM 390 Duke / Adventure
  • KTM 790 / 890 Duke
  • KTM 790 / 890 Adventure
  • KTM 1290 Super Duke R
  • KTM 1290 / 1390 Super Adventure
  • KTM Husqvarna Svartpilen / Vitpilen / Norden

The list is a guide, not a promise. ECU support changes with the model year. Send us yours and we check it before you ride over.

How we get into a KTM & Husqvarna ECU

KTM and Husqvarna ECUs are read and written with KESS3, by diagnostic plug on some models and on the bench on others.

About Alientech KESS3

Whichever tool reads it, the map is written the same way: a baseline dyno run, your stock file saved, fuelling corrected against the measured air/fuel ratio, then verification runs. The full method is on the ECU remap page.

How a tuning day runs

From your message to the before-and-after sheet

  1. 01 / 06

    You send the bike’s details

    Make, model, year and what is fitted. We check the ECU against the tools and tell you whether it is done through the diagnostic plug or on the bench.

  2. 02 / 06

    Check-in

    Chain, rear tyre, leaks and stored fault codes. Anything that would spoil the numbers or endanger the bike is dealt with first.

  3. 03 / 06

    Baseline runs

    The bike goes on the rollers as it arrived. Power, torque and air/fuel ratio are recorded so there is something honest to compare with.

  4. 04 / 06

    Stock file saved

    The original contents of the ECU are read and archived. From here on everything can be undone.

  5. 05 / 06

    Mapping

    Fuel is corrected against the measured air/fuel ratio across revs and throttle positions. Ignition, throttle maps and the agreed settings follow, where the ECU allows it.

  6. 06 / 06

    Verification runs

    The new map is run again until the trace sits where it should. You get the before-and-after sheet and we walk you through it.

KTM & Husqvarna tuning questions

Can you remap my KTM & Husqvarna in Phuket?

Most fuel-injected KTM & Husqvarna models can be remapped at our workshop in Kamala, using Alientech KESS3. Support depends on the model year and the ECU fitted, so send us make, model and year and we confirm before you book.

How much power will I gain?

It depends on the bike and what has been done to it. A stock modern bike usually gains little at the peak and noticeably more in the mid-range and in throttle smoothness. A bike with a full exhaust on its stock map gains the most, because the map is the furthest from right. We show you the baseline before any work, so you see the real difference on paper.

Is the remap reversible?

Yes. Before changing anything we read your original ECU file and keep it. It can be written back at any time — before a sale or a dealer visit.

How long does it take?

A power run takes about an hour. A custom remap takes from half a day to a full day, longer if the ECU has to come off the bike for bench work or if the engine is heavily modified.

Will a remap affect my warranty?

It can. A manufacturer may refuse a warranty claim on an engine whose ECU has been modified. We keep your original file so the bike can be returned to stock, but you should decide with that in mind.

Other makes

Booking

Send us the bike, the year and what is fitted.

We check that your ECU is supported, tell you which tool it needs and what it costs, then give you a slot.

WhatsApp +66 80 681 6753 LINE @phuketgarage

Daily 08:00–20:00, by appointment

Book a dyno slot